BayamOur projectsHardware
Building our own access hardware
When off-the-shelf readers and controllers do not fit, we design the boards ourselves — then test them on site.
What's going on
Some sites need a reader or controller that simply is not sold — the right protocols, the right number of floors, or a box that fits where the old one was.
What we do
We design the circuit board, write the firmware and build prototypes. Each one is tested on the bench with real cards and wiring before it goes anywhere near a door or lift.
Before we leave
The finished hardware is installed by the same team, labelled, and supported by us — so there is no waiting on an overseas supplier when something needs fixing.
What's included
- Circuit board design
- Firmware written in-house
- Prototypes tested on the bench
- Installed and labelled on site
- Supported by the team that built it
Got the same problem?
Send us a few photos of what you have now. We will tell you if it is a quick fix, a swap or a new install.